• The Roundup Ready designation indicates that the corn
contains a patented gene which provides tolerance to this
product. Information on Roundup Ready corn may be
obtained from your seed supplier.
NOTE: The instructions provided in this supplemental label
are specific to, and should only be used with, Roundup
Ready Corn 2 hybrids. Do Not combine the instructions in
this supplemental label with those in the “Corn With The
Roundup Ready Gene” section of the Buccaneer Plus
Glyphosate herbicide label booklet, or with any other
Roundup Ready corn instructions on labeling for this or
other glyphosate-containing product. See “Annual
Maximum Use Rate” in the “GENERAL INFORMATION”
section of the Buccaneer Plus Glyphosate herbicide label
booklet, for additional information.
The use of the higher in-crop over the top rates
described in this supplemental label on other than
Roundup Ready Corn 2 may cause crop injury and
reduce yields.
Application Instructions
For Roundup Ready Corn 2 from emergence through the V8
stage (8 leaves with collars) or until corn height reaches 30
inches, whichever comes first, this product may be applied
over-the-top broadcast or with drop nozzles. When corn
height is 24 to 30 inches (free standing), for optimum spray
coverage and weed control, drop nozzles are recommended.
For corn heights 30 to 48 inches (free standing), apply this
product only using ground application equipment with drop
nozzles adjusted to avoid spraying into the whorls of the
corn plants.
Single in-crop applications of this product should not exceed
48 fluid ounces per acre.
Maximum Allowable Combined Application
Quantities Per Season
Preplant, At-Planting, Preemergence: Maximum amount
of this product which can be applied prior to crop
emergence is 5.0 quarts per acre.
Postemergence (in-crop): Maximum combined total of
multiple in-crop applications from emergence through the
48 inch stage is 3 quarts per acre.
Preharvest: Maximum preharvest application rate after
maximum kernel fill is complete and the crop is
physiologically mature (black layer formation) with 35
percent grain moisture or less until 7 days before harvest is
1 quart per acre. See Precautions and Restrictions on
preharvest applications.
Cropping Season: Combined total per year for all
applications may not exceed 8.0 quarts per acre.
The addition of 1 to 2 percent dry ammonium sulfate by
weight or 8.5 to 17 pounds per 100 gallons of water may
increase the performance of this product under hard water
conditions, drought conditions or when tank mixed with
Bullet
®
or Micro-Tech
®
herbicides. Ensure that ammonium
sulfate is completely dissolved in the spray tank before
adding herbicides. Thoroughly rinse the spray system with
clean water after use to reduce corrosion. The addition of
other additives, including surfactants, fertilizers and/or
micro-nutrients are not recommended with this product
since this may result in increased potential for crop injury.
ATTENTION: AVOID DRIFT. EXTREME CARE MUST BE
USED WHEN APPLYING THIS PRODUCT TO PREVENT
INJURY TO DESIRABLE PLANTS AND CROPS WHICH
DO NOT CONTAIN THE ROUNDUP READY GENE.
THOROUGHLY CLEAN THE SPRAY TANK AND ALL
LINES AND FILTERS TO ELIMINATE POTENTIAL
CONTAMINATION FROM OTHER HERBICIDES PRIOR
TO MIXING AND APPLYING THIS PRODUCT.
For ground applications
: Use the recommended rates of
this product in 5 to 20 gallons of spray solution per acre as
a broadcast spray. Carefully select correct nozzles and
spray pressure to avoid spraying a fine mist. Check for
even distribution of spray droplets.
For aerial applications
: Use the recommended rates of this
product in 3 to 15 gallons of spray solution per acre. Do not
exceed 32 fluid ounces per acre. See “ANNUAL WEEDS
RATE TABLE” section on this label. AVOID DRIFT―DO
NOT APPLY DURING INVERSION CONDITIONS, WHEN
WINDS ARE GUSTY OR UNDER ANY OTHER
CONDITIONS WHICH FAVOR DRIFT. DRIFT MAY
CAUSE DAMAGE TO ANY VEGETATION CONTACTED
TO WHICH TREATMENT IS NOT INTENDED. TO
PREVENT INJURY TO ADJACENT VEGETATION,
APPROPRIATE BUFFER ZONES MUST BE
MAINTAINED.
Weed Control Recommendations
Apply 24 to 32 fluid ounces of this product per acre for
control of labeled grasses and broadleaf weeds in
conventional and no-till corn production systems. Refer to
the label booklet for Buccaneer Plus Glyphosate herbicide
for rate recommendations for specific annual weeds.
Buccaneer Plus Glyphosate herbicide applied at up to 48
fluid ounces per acre will control or suppress the growth of
perennial weeds such as: Bermudagrass, Canada thistle,
common milkweed, field bindweed, hemp dogbane,
horsenettle, nutsedge, quackgrass, rhizome johnsongrass,
redvine, trumpetcreeper, swamp smartweed, and wirestem
muhly. For additional information on perennial weeds, see
the “PERENNIAL WEEDS RATE TABLE” of the label
booklet for Buccaneer Plus Glyphosate herbicide.
Preplant, Preemergence, At-Planting
USE INSTRUCTIONS: This product may be applied alone
or in a tank-mixture before, during or after planting corn.
TANK MIXTURES: This product may be tank mixed with
Bullet, Degree
®
, Degree Xtra
®
, Harness
®
, Harness Xtra,
Harness Xtra 5.6L, Lariat
®
, Lasso
®
or Micro-Tech at 50 to
100 percent of labeled rate. Refer to the specific product
label and observe all precautions and limitations on the
label for any preemergence herbicide application, including
application timing restrictions, soil restrictions, minimum
recropping interval and rotational guidelines―the more
restrictive requirements apply.
NOTE: For maximum weed control, a postemergence (in-
crop) application of this product should be applied following
the use of less than labeled rates of the preemergence
residual products listed above.
Preemergence followed by Postemergence Weed
Control Program
USE INSTRUCTIONS: This product may be applied
postemergence in-crop following any labeled preemergence